© 2019 Closets.com
21
A:
Place a push-in dowel in the top front and back holes of
each panel and in the fourth hole from the bottom. (See
diagram & image 1). Locate where your center shelf will be
and place two more push-in dowels at the same level on
each panel. NOTE: In this example, instructions illustrate a
single section unit. If your system is more than on section,
refer to step 3B in the suspended system instructions.
B:
Install a European universal bracket in holes 2 & 3 from
the bottom of the panel near the front edge. This will
later be used to install your toe kick in Step 4. Use two
European 10mm screws. Holding the short side of the
universal bracket against the panel, fix the bracket to
the panel with your cordless drill on both left and right
panels. (Diagram 2, image 2).
TIP:
Install the European universal bracket with the short
side against the panel.
Diagram 1
IMAGE 1
Diagram 2
IMAGE 2
TOOLS NEEDED FOR INSTALLATION
TOOLS NEEDED FOR INSTALLATION
C:
Suspend the prepped panels from the rail installed in
Step 1. Review page 15 (suspended systems) for details.
Both suspended and floor-based closet systems use rail to
secure the system to the wall. Review pages 14-15 for details
on hanging the rail and panels for your closet system.
A:
Install the rail to be used by your closet system. Snap on the
rail cover after the rail is hung.
B:
Install the suspension brackets on your panels so that they
can be hung from the rail.
Note:
Panels are numbered and correspond to your drawings.
Each panel has a specific place. Be sure to confirm panel
location with your drawing.
