32
PANTRY PULL-OUT
The slide systems used with our drawers are the exact same group of components that are used when installing pantry or sweater
pull-outs.
The system uses a two part runner. Pull-out boxes will have the guides already fixed to the pull-out box. You will need to install the
pullout glides to the inside of each panel (See diagram 1) where a pullout will be inserted. Glides for pull-out boxes should always
be installed in the first visible hole on the panel above the fixed shelf.
A:
Install pull-out glides on the inside of the panel. Each
pull-out will have two glides per box. There is a center hole
drilled in the panel for installing the glide to the panel. In
the example below, there are two glides being installed.
Hold the pull-out runner up to the panel with the front
of the runner aligned with the front edge of the system.
Secure the center hole screw in the center of the runner
using a
10mm euro screw
. Use your cordless drill with a no
2 Phillips bit attached to secure it to the panel. Align the
front largest hole of the runner to the front hole on the
panel and secure to the panel with another
10mm euro
screw
. Do the same for the third hole. (See diagram 1 &
image 1 & 2).
STEP 3:
Place a pull-out box into the runner by holding it
level and parallel to the panels. Rest the box up against the
runner and slowly push it into place. You will feel a small
amount of resistance half way through. Continue pushing
the box in until it is fully inserted. Open the pullout to
confirm it is on the track correctly. (See image 3 to view the
pantry pull-out in operation).
TIP:
Pull-outs can be removed by opening the box while
pressing the black release levers on the side of the box.
One lever should be pressed down while the other is
pulled up. This disengages the locking mechanism so the
pull-out box can be removed.
Note:
When sliding boxes in place, make sure the slide
attached to the panel is pushed fully closed before the drawer
is put in place.
Note:
Pull-outs should only be installed once the entire system
has been assembled, leveled, and fixed in place.
Note:
Slide bearing cages to front of runner for ease of install.
STEP 2:
Repeat step 1 on the left panel. Once all pantry
pull-out runners are installed on the inside of the panels,
the pull-out boxes are ready to be put in place.
FRONT
OF SYSTEM
1
2
PANTRY PULL-OUT
RUNNERS
Diagram 1
IMAGE 1
IMAGE 2
IMAGE 3
