© 2019 Closets.com
27
STEP 2:
Locate the
third hole
(second down and third
over) in the front of the
metal slide. Resting the
slide against the shelf,
align this hole with the
pre-bored hole in the side
panel. The rear hole will
automatically align with
another pre-bored hole
in back. (Runners that
are resting directly on shelves, may require the screws to be
inserted on a slight angle down).
STEP 3:
Secure the first drawer
slide to the system panel
using the supplied screws.
Starting with the right
slide, front holes, align the
third hole
of the slide to
panel’s pre-
drilled hole
and secure
it with the
Euroscrew screw 10mm
x
7/16”
(item 1149)
.
STEP 4:
Proceed to secure the
rear hole of the slide with
another Euroscrew 10mm
x
7/16” screw. The holes will
automatically align with
one of the pre-bored
panel system holes if step
2 was correctly completed.
STEP 5 :
Repeat steps 1-3 to install
the opposite drawer slide.
STEP 6:
Push runners back. Slide
drawer in — it will lock
into place.
STEP 7:
All drawers
are
adjustable up and
down by moving the
adjustment knob
in
the corner of
the
drawer clips (see picture).
Use this knob to fine
tune the space between the
drawer fronts.
ADJUSTMENT KNOB
STEP 8 :
To Remove Drawer Box:
Open drawer, reach under
drawer and depress the
“Release Lever” in the front
right and left side of the
underside of the drawer
box. Then drawer can be
lifted out of the system.
RELEASE LEVER
Note:
Drawers should only be installed once the entire system has
been assembled, leveled and fixed in place.
