Installation Guide_PV-ezRack_SolarTerraceIII-A_AU_V2.0
1/10 Duerdin Street, Clayton VIC 3168 Australia
Tel: +61 3 9239 8088 Fax: +61 3 9239 8024
E-mail: [email protected] www.clenergy.com.au
22
page
of 28
18
18
Installation Instruction
Step 2 Slightly lift the PV Module and slide the Inter Clamps and Grounding Clips into position. The
teeth on Grounding Clip will be automatically aligned when the Inter Clamp is properly installed as
shown in Figure 20.
Step 3 Place the next framed PV Module into the other side of Inter Clamp and Grounding Clip as
shown in Figure 21.
Important Notes:
- To fix the Grounding Clip properly, ensure the frames of the PV Modules are now firmly pressed
against the Inter Clamp and Grounding Clip and visually check that Grounding Clips are positioned
properly. (Grounding Clips are intended for SINGLE USE ONLY!)Only fasten the bolts down when you
are sure the PV modules are in the correct position and lightly tighten the bolts at this stage to keep
the PV Modules in place.
Fig. 21
Fig. 20
Step 4 When using End and Inter clamps, maintain
an18mm vertical and horizontal gap between the
two adjacent rows of PV Modules. You can use
two Inter Clamps as separation between two PV
Modules to achieve this and remove them after the
installation is completed as shown in Figure 22.
Fig. 22
