35
To remove the part from the bender, remove the pin that holds the sharp-
angle-bend attachment.
FINISHING
Tack-weld the pieces together. Re-check that the straight legs are parallel.
Grind and sand all sharp corners.
LETTER O
STOCK REQUIRED:
• 3/16” STOCK; 2” MAX WIDTH
• 1 X 14” Blank
• 1 x 3-7/8” Blank
SETUP
Make a letter “C” from the 14”
blank as shown on page 17
.
FINISHING
Tack-weld the two pieces together as shown. Grind and sand all sharp
corners.
LETTER P
STOCK REQUIRED:
• 3/16” STOCK; 2” MAX WIDTH
• 1 X 8-7/8” Blank
• 1 x 6” Blank
SETUP
Make part of a letter “B” (page16)—the straight
piece and one loop.
FINISHING
Tack-weld the pieces together. Grind and sand all sharp corners
