31
LETTER J
STOCK REQUIRED
• 3/16” stock; 2” max.
width
• 1 x 10in blank
SETUP
Make chalk marks on the
blanks as shown on the
“Bend Sequence.”
BEND NO. 1
Insert the blank into the bender to the #1 chalk mark, (as in A), and bend it to
45°. Re-check the angle before you go on to the second bend.
Chalk mark the ring, or set a stop, for ease of repeating the 45° bend.
BEND NO. 2
Slide the stock to the #2 chalk mark (as in B), and bend it to 45°. Re-check the
angle.
BEND NO. 3
Slide the stock to the #3 chalk mark (as in C), and bend it to 45°. Re-check the
angle.
To remove the part from the bender, remove the pin that holds the sharp-
angle-bend attachment.
FINISHING
Grind and sand all sharp corners.
