4
ASSEMBLY
1. To attach the ring assembly to the
stand (refer to the illustration
opposite):
a. Attach the loop end of the ring
assembly to the stand. Use the long bolt,
flat washer, thick spacer (inside the
loop), thin spacer, lock washer, and lock
nut.
b.Attach the ring end to the stand with
the two flat-head bolts, using thin
spacers, flat washer, lock washers, and
lock nuts.
2. Insert the loop end of the handle
inside the loop of the ring assembly,
and secure it by inserting one of the
two longer hitch pins.
3. Remove the 'R' clip from the handle
pin then remove the pin from the
handle. Pull out the extension arm,
install the pin in the outer hole, and
reinstall the 'R' clip.
4. Set the bender in the position where
you intend it to be used. Rotate the
handle as far as it will go in both directions, to be sure there will be no
obstructions when bending.
5. Attach the bender’s base securely to the floor.
