54
Clare Controls IP Network Camera User Guide
Arming or disarming the camera
This section if for supported cameras only. Follow the steps below to configure all-day
arming for the camera with the wireless alarm, PIR alarm, motion detection, video
tampering, etc.
Notes
The emergency alarm is enabled and armed by default.
The arming and disarming function can be set by the remote control.
To arm the camera:
1. Enter the Remote Control interface.
Configuration > Camera Configuration > System > Remote Control
2. Select
Arm
from the
Arm/Disarm
drop-down list.
3. Set the arming delay.
Note:
Arming delay refers to a time delay to arm the camera after you set it. You can
set the delay as 10 seconds, 30 seconds, 1 minute, 3 minutes, 5 minutes, or
customize the delay time.
4. Click
Set
to arm the camera.
To disarm the camera:
In the Remote Control interface, select
Disarm
from the
Arm/Disarm
drop-down list
and click
Set
to disarm the camera.
Note:
You can press the Arm/Disarm button on the remote control to arm/disarm the
camera if the camera has already studied the remote control.
The arming indicator glows red when the camera is armed and glows blue when
it is disarmed.
Summary of Contents for IP Network Camera
Page 1: ...Clare Controls IP Network Cameras User Guide Doc ID 2014 12 343 Rev 04...
Page 2: ......
Page 8: ...iv Clare Controls IP Network Camera User Guide...
Page 92: ......