Configuring SNMP
Notification Recipients
Cisco 500 Series Stackable Managed Switch Administration Guide
420
22
•
Link Local Interface
—If the IPv6 address type is Link Local, select whether
it is received through a VLAN or ISATAP.
•
Recipient IP Address
—Enter the IP address of where the traps are sent.
•
UDP Port
—Enter the UDP port used for notifications on the recipient device.
•
Notification Type
—Select whether to send Traps or Informs. If both are
required, two recipients must be created.
•
Timeout—Enter the number of seconds the device waits before re-sending
informs.
•
Retries—Enter the number of times that the device resends an inform
request.
•
Community String—Select from the pull-down the community string of the
trap manager. Community String names are generated from those listed in
the Community page.
•
Notification Version
—Select the trap SNMP version.
Either SNMPv1 or SNMPv2 may be used as the version of traps, with only a
single version enabled at a time.
•
Notification Filter
—Select to enable filtering the type of SNMP notifications
sent to the management station. The filters are created in the
Notification
Filter
page.
•
Filter Name
—Select the SNMP filter that defines the information contained
in traps (defined in the
Notification Filter
page).
STEP 4
Click
Apply
. The SNMP Notification Recipient settings are written to the Running
Configuration file.
Defining SNMPv3 Notification Recipients
To define a recipient in SNMPv3:
STEP 1
Click
SNMP
>
Notification Recipients SNMPv3
. The
Notification Recipients
SNMPv3
page is displayed.
This page displays recipients for SNMPv3.
STEP 2
Click
Add.
The
Add SNMP Notification Recipient
page is displayed.
STEP 3
Enter the parameters.
