VLAN Management
VLAN Groups
Cisco 500 Series Stackable Managed Switch Administration Guide
213
13
STEP 3
Enter the values for the following fields:
•
Group Type
—Displays that the group is MAC-Based.
•
Interface
—Enter a general interface (port/LAG) through which traffic is
received.
•
Group ID
—Select a VLAN group, defined in the
MAC-Based Groups
page
.
•
VLAN ID
—Select the VLAN to which traffic from the VLAN group is
forwarded.
STEP 4
Click
Apply
to set the mapping of the VLAN group to the VLAN. This mapping
does not bind the interface dynamically to the VLAN; the interface must be
manually added to the VLAN.)
Protocol-based VLANs
Groups of protocols can be defined and then bound to a port. After the protocol
group is bound to a port, every packet originating from a protocol in the group will
be assigned the VLAN that is configured in the
Protocol-Based Groups to VLAN
page.
Workflow
To define a protocol-based VLAN group:
1. Define a protocol group (using the
Protocol-Based Groups
page).
2. For each required interface, assign the protocol group to a VLAN (using
Protocol-Based Groups to VLAN
page). The interfaces must be in General mode
and cannot have a Dynamic VLAN (DVA) assigned to it.
Protocol-Based Groups
Use the
Protocol-Based Groups
page to define a set of protocols.
STEP 1
Click VLAN Management >
VLAN Groups
> Protocol-Based Groups. The
Protocol-Based Groups
page is displayed.
The
Protocol-Based Groups Page
contains the following fields:
•
Encapsulation—Displays the protocol on which the VLAN group is based.
