12-45
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 12 Value Added Services (VAS) Traffic Forwarding
VAS over 10G
How to Enable the Health Check for VAS over 10G Topology
Use this command to configure the health check to adjust to VAS over 10G (MGSCP) conditions (see
Health Check in VAS over 10G Topology, page 12-39
).
•
Options, page 12-45
•
How to Enable Health Check Compatibility for VAS over 10G (MGSCP), page 12-45
•
How to Remove the Health Check Compatibility Configuration, page 12-45
Options
The following options are available:
•
The keyword
MGSCP
is specified to enable health check compatibility because VAS over 10G is a
special case of a MGSCP (Multi-Gigabit Service Control Platform) system.
–
By default, VAS over 10G compatibility is disabled.
How to Enable Health Check Compatibility for VAS over 10G (MGSCP)
Step 1
From the SCE(config if)# prompt, type
VAS-traffic-forwarding health-check topology MGSCP
and
press
Enter
.
How to Remove the Health Check Compatibility Configuration
Step 1
From the SCE(config if)# prompt, type
no VAS-traffic-forwarding health-check topology MGSCP
and press
Enter
.
You can also use the
default
form of the command:
default VAS-traffic-forwarding health-check topology MGSCP