![background image](http://html.mh-extra.com/html/cisco/sce-1000-and/sce-1000-and_configuration-manual_64496357.webp)
12-43
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 12 Value Added Services (VAS) Traffic Forwarding
VAS over 10G
How to Set the Active VAS Link
•
Options, page 12-43
•
How to Set the Active VAS Link, page 12-43
•
How to Revert to the Default Active VAS Link Configuration, page 12-43
Use this command to set the active VAS link, the link on which to transmit VAS traffic after a system
reload and when working in auto-select mode.
When executed, this command triggers an immediate link switch if the currently active VAS traffic link
used is different from the one specified in the command.
Options
The following option is available:
•
VAS traffic-link {link-0|link-1}
— The link number on which to transmit VAS traffic
–
Default — Link 1
How to Set the Active VAS Link
Step 1
From the SCE(config if)# prompt, type
VAS-traffic-forwarding traffic-link auto-select
initial-selection {link-0 | link-1}
and press
Enter
.
How to Revert to the Default Active VAS Link Configuration
Step 1
From the SCE(config if)# prompt, type
no VAS-traffic-forwarding traffic-link auto-select
initial-selection
and press
Enter
.
You can also use the
default
form of the command:
default VAS-traffic-forwarding traffic-link auto-select initial-selection
How to Configure Health Check for VAS over 10G
•
How to Configure the Health Check IP Address, page 12-43
•
How to Remove the IP Address Configuration, page 12-44
When configuring the health check for VAS over 10G, you must perform the following steps:
•
Configure the health check source and destination IP addresses
•
Enable health check compatibility for VAS over 10G
How to Configure the Health Check IP Address
•
About the Health Check IP Address, page 12-44
•
Options, page 12-44