Cisco Prisma II HD-LRMW, Installation And Operation Manual

Page: 88 / 128

Chapter 4 Operation Using LCI
64
LCI Introduction
Laser Warning
WARNING:
¡
Avoid personal injury! Use of controls, adjustments, or procedures other
than those specified herein may result in hazardous radiation exposure.
¡
Avoid personal injury! The laser light source on this equipment (if a
transmitter) or the fiber cables connected to this equipment emit invisible
laser radiation. Avoid direct exposure to the laser light source.
¡ Avoid personal injury! Viewing the laser output (if a transmitter) or fiber
cable with optical instruments (such as eye loupes, magnifiers, or
microscopes) may pose an eye hazard.
¾
Do not apply power to this equipment if the fiber is unmated or unterminated.
¾
Do not stare into an unmated fiber or at any mirror-like surface that could reflect
light emitted from an unterminated fiber.
¾
Do not view an activated fiber with optical instruments such as eye loupes,
magnifiers, or microscopes.
¾
Use safety-approved optical fiber cable to maintain compliance with applicable
laser safety requirements.
¾
Even if the unit is off, there may still be hazardous optical levels present.
LCI Function
LCI is software that functions as a user interface for the Prisma II platform.
LCI is installed on a computer, which is then connected to a Prisma II Chassis.
Using LCI, you can configure and monitor the modules in the chassis to
which the computer is connected.
Important: Do not operate any Prisma II Chassis without a fan tray installed.
If a fan tray is not installed in the Prisma II Chassis, the LCI will not
communicate with any of the power supplies in that chassis.