Chapter 2 Module Installation
30
Connecting Optical Cables
To Connect Optical Cables to an HD Module
Note:
This procedure assumes that the chassis is mounted in a rack.
Important:
Observe laser safety precautions. Refer to the
Laser Safety
information earlier in this guide.
Complete the following steps for each optical cable to be connected to the
module.
1
Attach one end of the optical cable to the optical output connector located
on the front of the module.
2
Route the other end of the optical cable to the appropriate destination.
Summary of Contents for Prisma II HD-LRMW
