Channelized T1 Port Adapter Installation and Configuration 37
Using the EXEC Command Interpreter
Figure 20
Connecting a 2CT1 Interface Cable (2CT1 Port Adapter Front View—Shown
Without Handle)
Step 2
Attach the network end of the cable to your Primary Rate Interface (PRI) channel service
unit (CSU) and tighten the strain-relief screws.
This completes the procedure for attaching a 2CT1 interface cable.
Using the EXEC Command Interpreter
You modify the configuration of your router through the software command interpreter called the
EXEC. You must enter the privileged level of the EXEC command interpreter with the enable
command before you can use the configure command to configure a new interface or to change the
existing configuration of an interface. The system prompts you for a password if one has been set.
The system prompt for the privileged level ends with a pound sign (#) instead of an angle bracket
(>). At the console terminal, use the following procedure to enter the privileged level:
Step 1
At the user-level EXEC prompt, enter the enable command. The EXEC prompts you for
a privileged-level password:
Router> enable
Password:
Step 2
Enter the password (the password is case sensitive). For security purposes, the password
is not displayed.
H9235
EN
LB
LA
RA
0
1
LB
LA
RA
To PRI CSU
Strain-relief screw
