6-9
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
OL-11503-01
Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
Configuring Asynchronous/Synchronous Serial Network Modules or WAN Interface Cards
interface Vlan10
no ip address
!
interface Vlan11
ip address 41.42.43.206 255.255.255.0
no ip proxy-arp
load-interval 30
!
interface Vlan12
no ip address
no ip proxy-arp
no ip mroute-cache
load-interval 30
shutdown
!
interface Vlan20
no ip address
!
Configuring Asynchronous/Synchronous Serial Network
Modules or WAN Interface Cards
The interfaces on the Asynchronous/Synchronous serial network modules or WAN interface card can be
configured for synchronous or asynchronous serial protocols. HDLC (synchronous) and PPP
(asynchronous or synchronous) are typical serial protocols.
Note
For complete information on configuring serial interfaces, see the
Configuring Serial Interfaces
chapter of the
Cisco IOS Interface Configuration Guide, Release 12.2
:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/finter_c/index.htm
To configure a serial interface, complete the following tasks, beginning in global configuration mode:
Command
Purpose
Step 1
Router(config)# interface serial 0/0
Router(config-if)#
Enter the interface configuration mode. You have
entered interface configuration mode when the
prompt changes to
Router(config-if)#.
Step 2
Router(config-if)# ip address 172.16.74.1
255.255.255.0
Assign the IP address and subnet mask to the
interface.
Step 3
outer(config-if)#
encapsulation
encapsulation_type
Set the encapsulation method, (for example,
HDLC, PPP, Frame-Relay) used by the interface.
Step 4
Router(config-if)# physical-layer async
All serial ports are initially configured as
synchronous. Enter this command if you want to
configure the port as asynchronous.
Step 5
Router(config-if)# async mode dedicated
Router(config-if)# async default routing
Configure asynchronous parameters according to
your needs.
Step 6
Router(config-if)# line async <#>
Configure the asynchronous line setting.
Summary of Contents for MWR 1941-DC - 1941 Mobile Wireless Router
Page 49: ...P A R T 1 Implementing the MWR 1941 DC Router in an IP RAN ...
Page 50: ......
Page 107: ...P A R T 2 Implementing the MWR 1941 DC Router in a Cell Site DCN ...
Page 108: ......