Cisco MWR 1941-DC - 1941 Mobile Wireless Router, Software Configuration Manual

Page: 92 / 184

5-12
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
OL-11503-01
Chapter 5 Cisco MWR 1941-DC Router IP-RAN Command Reference
ppp mux delay
ppp mux delay
To set the maximum time the processor can wait before sending a superframe, use the ppp mux delay
command in interface configuration mode. To set the maximum delay to the default, use the no form of
this command.
ppp mux delay integer
no ppp mux delay
Syntax Description
Defaults The default maximum delay is 0, which indicates that a superframe will be sent when the transmit queue
is full.
Command Modes Interface configuration
Command History
Usage Guidelines To use this command, you must first enable PPP multiplexing/demultiplexing.
Examples The following example sets the maximum delay to 5 microseconds.
ppp mux delay 5
Related Commands
integer The maximum number of microseconds that the processor can wait before
sending out a PPP superframe. Possible values are 0 through 4000000
microseconds.
Release Modification
12.2(8)MC2 This command was introduced.
12.2(15)MC1 This command was incorporated in Cisco IOS 12.2(15)MC1.
12.3(11)T This command was incorporated in Cisco IOS 12.3(11)T.
Command Description
ppp mux Enables PPP multiplexing/demultiplexing
ppp mux frame Sets the maximum length of the PPP superframe.
ppp mux pid Sets the default PPP protocol ID.
ppp mux subframe count Sets the maximum number of subframes in a superframe.
ppp mux subframe length Sets the maximum length of the PPP subframe.
show ppp mux Displays PPP mux counters for the specified multilink interface.