Cisco MWR 1941-DC - 1941 Mobile Wireless Router, Software Configuration Manual

Page: 133 / 184

6-25
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
OL-11503-01
Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
Configuring the NM-AIC-64, Contact Closure Network Module
•
TFTP
• SNMP
The Cisco IOS software assigns an IP address to the AIC for use by the serial data channel. To route
traffic, the serial data channel uses IP over synchronous High-Level Data Link Control (HDLC). All IP
packets coming to the Cisco router with a destination IP address that matches the AIC’s IP address are
forwarded to the serial data channel using IP over HDLC.
Asynchronous Craft Port
The asynchronous craft port supports Telnet to the AIC’s port number. This Telnet method, called
local-CLI, is useful for debugging when remote Telnet to the AIC’s IP address (remote-CLI) is not
applicable. For more information, see the
“Configuring the NOC IP Address” section on page 6-30 .
The asynchronous craft port also supports an AIC boot sequence, similar to the ROM monitor in
Cisco IOS software, which allows the user to recover from a corrupted software image or configuration.
See the
“Override” section on page 6-36 .
Configuring the AIC
From a top-level view, AIC configuration involves assigning an IP address to the AIC using Cisco IOS
commands and setting up alarm configurations with either TL1 or the AIC command-line interface
(CLI). The flexible TL1 and AIC CLI permit a broad range of alarm configuration scenarios. The
following are examples of alarm configurations that can be programmed with the AIC CLI:
Configuring a Discrete Alarm
enable
config terminal
alarm 1
description "west door"
normally closed
description normal "door closed"
description alarm "door open"
level 2
exit
Configuring an Analog Alarm as an Analog Monitoring Voltage
enable
config terminal
alarm 57
description "tank level"
description normal "full"
description low "low"
description low-low "empty"
analog voltage 2.5 30 60 60
exit