3-6
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
OL-11503-01
Chapter 3 First-Time Configuration
Configuring Interface Parameters
FastEthernet0/0 172.18.46.74 YES NVRAM up up
FastEthernet0/1 150.0.1.0 YES NVRAM up up
Serial0/0:0 unassigned YES NVRAM up up
Serial0/1:0 unassigned YES NVRAM up up
Step 9
Specify the interface to be used to connect to the network management system.
Enter interface name used to connect to the
management network from the above interface summary:
FastEthernet0/0
Step 10
You are then prompted to configure the specified interface.
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [yes]:no
Configuring Interface Parameters
From this point on in the
setup
process, the prompts you see vary depending on the network modules
and WAN interface cards in place in your router. The following sections provide examples of the setup
steps for each interface module. Refer to the sections appropriate to your router’s configuration.
Configuration for network modules includes:
•
Ethernet Interface Configuration, page 3-6
•
FastEthernet Interface Configuration, page 3-7
•
Serial Interface Configuration, page 3-7
•
Asynchronous/Synchronous Serial Interface Configuration, page 3-10
When you complete the setup steps for your interface modules, go to the
“Completing the Configuration”
section on page 3-12
for directions on saving your configuration.
Ethernet Interface Configuration
This section contains a sample configuration for the Ethernet interface. Enter the values appropriate for
your router and network. The messages you see may vary.
Do you want to configure Ethernet0/0 interface [yes]:
Configure IP on this interface? [yes]:
IP address for this interface: 255.255.255.0
Subnet mask for this interface [255.0.0.0]:
Class A network is 1.0.0.0, 8 subnet bits, mask is /8
Configure IPX on this interface? [no]: y
IPX network number [1]:
Need to select encapsulation type
[0] sap (IEEE 802.2)
[1] snap (IEEE 802.2 SNAP)
[2] arpa (Ethernet_II)
[3] novell-ether (Novell Ethernet_802.3)
Enter the encapsulation type [2]:
Summary of Contents for MWR 1941-DC - 1941 Mobile Wireless Router
Page 49: ...P A R T 1 Implementing the MWR 1941 DC Router in an IP RAN ...
Page 50: ......
Page 107: ...P A R T 2 Implementing the MWR 1941 DC Router in a Cell Site DCN ...
Page 108: ......
