Cisco 2800 Series, Manual

Page: 47 / 266

5
Basic Software Configuration Using the Cisco IOS Command-Line Interface
OL-5593-01
How to Perform a Basic Software Configuration Using the Cisco IOS CLI
Troubleshooting Tips
If you forget the password that you configured, or if you cannot access privileged EXEC (enable) mode,
see the
Password Recovery Procedures for your router, available at
http://www.cisco.com/warp/public/474.
What to Do Next
If you want to set the console interface privileged EXEC timeout to a value other than 10 minutes (the
default), proceed to the
“Configuring the Console Idle Privileged EXEC Timeout” section on page 5 .
If you do not wish to change the privileged EXEC timeout, proceed to the “Specifying a Default Route
or Gateway of Last Resort” section on page 9 .
Configuring the Console Idle Privileged EXEC Timeout
This section describes how to configure the console line’s idle privileged EXEC timeout. By default, the
privileged EXEC command interpreter waits 10 minutes to detect user input before timing out.
When you configure the console line, you can also set communication parameters, specify autobaud
connections, and configure terminal operating parameters for the terminal that you are using. For more
information on configuring the console line, see the
Cisco IOS Configuration Fundamentals and
Network Management Configuration Guide . In particular, see the “Configuring Operating
Characteristics for Terminals” and “Troubleshooting and Fault Management” chapters.
Step 3
enable password password
Example:
Router(config)# enable password pswd2
(Optional) Sets a local password to control access to various
privilege levels.
•
We recommend that you perform this step only if you
boot an older image of the Cisco IOS software or if you
boot older boot ROMs that do not recognize the
enable
secret command.
Step 4
enable secret password
Example:
Router(config)# enable secret greentree
Specifies an additional layer of security over the enable
password command.
• Do not use the same password that you entered in
Step 3 .
Step 5
end
Example:
Router(config)# end
Returns to privileged EXEC mode.
Step 6
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Verify that your new enable or enable secret password
works.
Step 7
end
Example:
Router(config)# end
(Optional) Returns to privileged EXEC mode.
Command or Action Purpose