6-47
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Chapter 6 Setting Up and Managing User Groups
Configuration-specific User Group Settings
Note
To hide or display Nortel RADIUS attributes, see
Setting Protocol Configuration
Options for Non-IETF RADIUS Attributes, page 3-16
. A VSA applied as an
authorization to a particular group persists, even when you remove or replace the
associated AAA client; however, if you have no AAA clients of this (vendor) type
configured, the VSA settings do not appear in the group configuration interface.
To configure and enable Nortel RADIUS attributes to be applied as an
authorization for each user in the current group, follow these steps:
Step 1
Confirm that your IETF RADIUS attributes are configured properly.
For more information about setting IETF RADIUS attributes, see
Configuring
IETF RADIUS Settings for a User Group, page 6-37
.
Step 2
In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
Step 3
From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
Step 4
From the Jump To list at the top of the page, choose RADIUS (Nortel).
Step 5
In the Nortel RADIUS Attributes table, specify the attributes to be authorized for
the group by selecting the check box next to the attribute. Where applicable,
further define the authorization for that attribute in the field next to it. For more
information about attributes, see
Appendix C, “RADIUS Attributes”
, or the
documentation for network devices using RADIUS.
Note
The MS-CHAP-MPPE-Keys attribute value is autogenerated by
Cisco Secure ACS; there is no value to set in the HTML interface.
Step 6
To save the group settings you have just made, click Submit.
For more information, see
Saving Changes to User Group Settings, page 6-53
.
Step 7
To continue specifying other group settings, perform other procedures in this
chapter, as applicable.