4-66
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring Voice and Video Parameters
5.
To see the TSM statistics for a particular access point and a particular client associated to this access
point, enter this command:
show ap stats
{
802.11a
|
802.11b
}
ap_name
tsm
[
client_mac
|
all
]
The optional
all
command shows all clients associated to this access point. Information similar to
the following appears:
AP Interface Mac: 00:0b:85:01:02:03
Client Interface Mac: 00:01:02:03:04:05
Measurement Duration: 90 seconds
Timestamp 1st Jan 2006, 06:35:80
UpLink Stats
================
Average Delay (5sec intervals)............................35
Delay less than 10 ms.....................................20
Delay bet 10 - 20 ms......................................20
Delay bet 20 - 40 ms......................................20
Delay greater than 40 ms..................................20
Total packet Count.........................................80
Total packet lost count (5sec).............................10
Maximum Lost Packet count(5sec)............................5
Average Lost Packet count(5secs)...........................2
DownLink Stats
================
Average Delay (5sec intervals)............................35
Delay less than 10 ms.....................................20
Delay bet 10 - 20 ms......................................20
Delay bet 20 - 40 ms......................................20
Delay greater than 40 ms..................................20
Total packet Count.........................................80
Total packet lost count (5sec).............................10
Maximum Lost Packet count(5sec)............................5
Average Lost Packet count(5secs)...........................2
Note
The statistics are shown in 90-second intervals. The timestamp field shows the specific
interval when the statistics were collected.
6.
To enable or disable debugging for call admission control (CAC) messages, events, or packets, enter
this command:
debug cac
{
all
|
event
|
packet
}{
enable
|
disable
}
where
all
configures debugging for all CAC messages,
event
configures debugging for all CAC
events, and
packet
configures debugging for all CAC packets.
