Circutor SVGm-3WF-100C-480, Instruction Manual

Page: 69 / 102

69
Instruction Manual
SVGm
8�2�2�4�- SVGm messages
Table 29: Modbus memory map: Static generator messages (Table 1)�
Parameter Address
Device status
(4)
110
Bit Description Status
0x0001 Stop
1 : ON
0 : OFF
0x0002 Start
0x0004 Reset alarms
(4)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
Table 30: Modbus memory map: Static generator messages (Table 2)�
Parameter Address
Alarm messages 105 (Hi value), 106 (Low value)
Bit Description
0x00000000 There are no alarms
0x00000002 L1 overcurrent alarm
0x00000004 L2 overcurrent alarm
0x00000008 L3 overcurrent alarm
0x00000010 L1 overvoltage alarm
0x00000020 L2 overvoltage alarm
0x00000040 L3 overvoltage alarm
0x00004000 Temperature IGBT 1 alarm
0x00008000 Temperature Inductor 1 alarm
0x00010000 Initial Conditions Error
0x00100000 Contactor faults
0x00200000 Temperature Inductor 2 alarm
Table 31: Modbus memory map: Static generator messages (Table 3)�
Parameter Address
Initial Conditions for which the device does not start up.
(5)
108
Bit Description
0x0001 Discharging DC bus
0x0002 Minimum Mains Voltage
0x0004 Minimum temperature value
0x0008 Frequency error
0x0010 Charging DC bus
0x0020 Minimum DC bus voltage
0x0040 DC Bus imbalance
0x0080 The device does not communicate
0x0100 Polarity Error
0x0200 Minimum load current
0x0400 Maximum charge current
(5)
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.