Circutor Raption 100, Installation Manual

Page: 8 / 60

The charge point is designed for installation in indoor and outdoor areas. For each of the
different conditions of installation, the unit must be installed safely and ensure adequate
protection.
• Charge point must not be installed in
areas where there is potential risk of
explosion or any salinity level.
• Charge point must not be installed
in industrial areas with high level of
humidity or pollutants.
• Do not install the Charge point where
falling objects may damage the
equipment.
• The surface where the Charge point is
placed must withstand the mechanical
forces.
• Do not use this unit for anything other
than electric vehicle charging modes
are expected in IEC 61851.
• Do not modify this unit. If modified,
CIRCUTOR
will reject all responsibility
and the warranty will be void.
• Comply strictly with electrical safety
regulations according to your country.
• Do not make repairs or manipulations
with the unit energized.
• Only trained and qualified personnel
should have access to the electrical
parts inside the Charge point.
• Check the installation annually by
qualified technician.
• Remove from service any item that
has a fault that could be dangerous
for users (broken plugs, caps that don’t
close...).
• Use only
CIRCUTOR
supplied spare
parts.
• Do not use this unit if the enclosure or
the EV connector is broken, cracked,
open, or shows any other indication of
damage.
Read carefully all the instructions before starting in
order to ensure properly installation of the charge
point.
2
A
Important safety instruction
8
Raption
Installation Guide