Christie Solaria CP2210, User Manual

Page: 54 / 164

5-6 CP2210 User Manual
020-100410-07 Rev. 1 (01-2012)
Section 3: Operation
3. Tap OK .
4. Adjust the focus, Horizontal (X) and Vertical (Y) offset, and zoom by tapping the applicable button.
NOTE
: This does not over-write the system settings for the ILS. If
Enabled Automatic ILS
is selected again,
the ILS will position the lens to the saved channel settings.
5. If the
Quick Reset
or
Lens Calibration
buttons are tapped in the Advanced Setup: Lens Setup window, the
lens returns to this remembered location. Also, this setting is remembered across system resets and reboots.
5.6.5 Reset the ILS
The ILS must be reset when:
• the lens has been moved
• manual adjustments have been made to horizontal or vertical offset, zoom or focus
• a power outage occurred during a channel change
• ILS settings are drifting within a short period of time
1. On the
Main screen of the TPC, tap Lens Adjust.
2. Tap Quick Reset . If Enable Automatic ILS is not selected, the lens returns to the stored settings .
5.6.6 Calibrate the ILS
You must calibrate the ILS must when you install a new lens.
1. On the
Main screen of the TPC, tap Lens Adjust.
2. Tap Full Calibration . If Enable Automatic ILS is not selected, the lens returns to the stored settings .