Christie DD1-WU80P, Service Manual

Page: 63 / 150

61
DWU951 (DD1-WU80P/81P) / DWX951 (DD1-WX80P/81P) / DXG1051 (DD1-X100P/101P)
DWU951/DWX951/DXG1051 Service Manual
020-000674-01 Rev.1 (01-2014) Page 61 / 118
Disassembling
H›?„ § ”$'
@ H &%›?„*? §+
cable.
2) Release the STATUS MONITOR from 2 hooks on the
CONTROL BUTTON frame.
3) Tear off the tape and disconnect the harness from the
back side of the SUB LCD PCB.
4) Release the SUB LCD PCB from a hook on the
CONTROL BUTTON frame.
5) Disconnect the harness and tear off the tape from the
¡”V*>„*?
6) Remove 3 screws and the earth cable CNGD1 from the
¡”V*>„*?
Assembling
H&#¡”V*>„*??"¢„ ##
holding the frame to avoid warping it.
2) Fasten the SUB LCD PCB with a hook on the
CONTROL BUTTON.
3) Connect the harneses and tape them to the PCBs
as before.
4) Fasten the STATUS MONITOR on the CONTROL
BUTTON (frame) at 2 hooks, and turn the stopper
”$' &%›?„*? §+
cable.
5) Align the LCD cushion to the frame of CONTROL
BUTTON and stick it to the frame as shown in the
drawing.
NOTE:
The LCD cushion comes together with the
STATUS MONITOR of service parts.
Wiring
? ?"¡”V?"›?„
Be careful of the styling of CNGD1.
z
%!%€?=?^„%@ †‡Qˆ#! #„?^?@?
Hook
STATUS MONITOR
LCD cushion
CONTROL BUTTON
SUB LCD PCB
LCD c
XVK
ion
0~0.5mm
0~0.5mm
STATUS MONITOR
CONTROL BUTTON
LCD cushion
SUB LCD PCB
ER50
STATUS MONITOR
CONTROL BUTTON
Hook
Style CNGD1 as shown and
tape it (W=20mm).
Connect CNLCD.
? ?"¡”V
Check if the cable tie
?"¡”V?"›?„
at about 10mm from the
?"¡”V
•+'#
torque: 0.39~0.59N
·
m
¡”V*>„
PCB
Tape CNLCD (W=20mm).
¡”V*>„*?
Hold
Screw down the end of CNGD1 to point it upward.
Be careful not to let it be over the frame.