Christie D4K35, Setup Manual

Page: 21 / 66

Section 2: Installation and Setup
D4K35 Setup Guide 2-9
020-100855-02 Rev. 1 (09-2014)
2.8 Install the Touch Panel Controller (TPC)
1. Loosen the mounting arm just enough for the end to fit over the ball joint located on the rear panel of the
projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector on the rear panel of the projector.
4. Adjust the angle of the TPC.
19 mm wrench
Remove rear feet
Prop up rear of projector Add foot extension rod
2.
1. 3.
Figure 2-7 Using the Foot Extension Rods
Figure 2-8
Figure 2-9