Christie D4K35, Setup Manual

Page: 10 / 66

1-2 D4K35 Setup Guide
020-100855-02 Rev. 1 (09-2014)
Section 1: Introduction
1.2 AC / Power Precautions
To correctly install this projector, a certified electrician must install a permanent a single-phase connection
from the projector to the AC supply. Operate the projector at the recommended voltage.
Disconnect projector from AC before opening any enclosure.
1) DO NOT allow anything to rest on the power cord. Locate the projector where the cord
cannot be abused by persons walking on it or objects rolling over it. Never operate the
projector if the power cable appears damaged in any way.
2) DO NOT overload power outlets and extension cords as this can result in fire or shock
hazards.
3) Note that only qualified service technicians are permitted to open any enclosure on the
product and only if the AC has been fully disconnected from the product.
Power Cords and Attachments
1) Verify that you are using a line cord, socket and power plug that meets the
appropriate local rating standards. 2) Use only an AC power cord recommended by Christie.
Do not attempt operation if the AC supply and cord are not within the specified voltage and
power range.
Use only the attachments and/or accessories recommended by Christie. Use of others may result in the risk of
fire, shock or personal injury.
1.3 Lamp Precautions
Lamps used in the projector are under high pressure and you must handle them with caution. Lamps can
explode and cause serious personal injury if they are dropped or mishandled.
EXPLOSION HAZARD! Wear authorized protective safety gear whenever the
lamp door is open!
Recommended protective clothing includes, but may not be limited to a polycarbonate face shield,
protective gloves, and a quilted ballistic nylon jacket or a welder’s jacket. This equipment is included in
included in the Christie Protective Clothing Safety Kit #598900-095.
NOTE:
Christie’s protective clothing recommendations are subject to change. Any local or federal specifica-
tions take precedence over Christie recommendations.
Lamp may explode causing bodily harm or death. 1) Always wear protective
clothing whenever lamp door is open or while handling lamp. 2) Verify those within the
vicinity of the projector are also suited with protective clothing. 3) Never attempt to access
the lamp while the lamp is on. Wait at least 10 minutes after the lamp turns OFF before
powering down, disconnecting from AC and opening the lamp door.
WARNING
WARNING
DANGER
DANGER