Christie D4K35, Setup Manual

Page: 20 / 66

2-8 D4K35 Setup Guide
020-100855-02 Rev. 1 (09-2014)
Section 2: Installation and Setup
2.6 Secure the Projector
Use of the projector’s rear safety strap is MANDATORY to prevent it from
tipping. Secure the strap between the projector and the optional rack stand or any other
surface it is mounted to.
2.7 Adjust Tilt and Level the Projector
The projector’s rear safety strap must be in place before you adjust the
projector’s feet.
DO NOT
over-extend the feet. Make sure several threads are engaged into
the projector’s baseplate.
The D4K35 lens should be centered and parallel with the screen. This orientation ensures ideal lens
performance with minimal offset. If this position is not possible (such as when the projector is significantly
higher than the center of the screen), it is better to rely on offset rather than extra tilt.
Use a protractor to measure the degree of screen tilt and then extend or retract the projector feet to match this
angle.
NOTES:
The front-to-back tilt of the projector must not exceed 15°. This limit ensures safe lamp operation and
the proper positioning of the liquid cooling reservoir.
To adjust the vertical or horizontal position of the projector, extend or
retract the adjustable feet on the bottom of the projector by rotating them.
Once the required adjustment is made, tighten the lock nut. (
Figure 2-6 )
If you need to adjust the vertical or horizontal position of the projector
beyond what the standard feet allow, you can install two 6 inch extension
rods to increase the amount of adjustment. To install the extension rods
safely:
1. Prop the rear of the projector up to access and remove the two rear
feet. This can be done by one person holding the back end of the
projector up slightly so another person can unthread the feet OR by
propping up the back of the projector with a sturdy object.
2. Add the extension rods to the standard feet.
3. Thread the extended feet into the projector’s baseplate. Adjust the
feet until the desired tilt is achieved.
4. Lock the feet in place by turning each lock nut until it fits tight against the projector.
WARNING
WARNING
WARNING
Figure 2-6 Adjust Feet