Chino AL3000 SERIES, Instructions Manual

Page: 87 / 116

15-1
15. OTHER OPTIONS
15.1. High-Speed Trace Printing
Selecting display appears at optional high-speed trace printing only. The trace printing interval can be
selected out of about 5 sec. (standard trace printing) or about 2.5 sec. (high-speed trace printing).
1. Selecting flow chart
<Example> Standard trace printing high-speed trace printing
Operation screen
  
  
  
Stored
Display
High-speed
trace printing
Standard
trace printing
Measured value About 5 sec./6 points
Multi-point
sequential
bargraph
About
2.5 sec.
About
5 sec.
One-point
continuous
bargraph
About 5 sec.
The intervals depend more or less upon the
measuring conditions (over-range, etc.).
Renewal intervals of various displays
In order to prevent overlap of printing, the
following restriction is specified when the
chart speed is lower than 11 (mm/h).
Printing interval (sec) =
180
CS×CH
C S: Chart speed (mm/h)
CH: Channel numbers
(excluding skipped channels)
The printing interval of lower than 2.5(sec.)
becomes 2.5 sec. and a decimal value is
carried up.
<Trace printing intervals on 6 channels>
Chart
speed
Intervals
Chart
speed
Intervals
1 30 sec. 6,7 5 sec.
3 10 sec. 8,9 4 sec.
5 6 sec. 10,11 3 sec.
Printing intervals of high-speed trace printing
The trace-printing intervals become
short. If measured values change a
little, trace printings may overlap each
other to cause the chart to be broken.
Select the standard trace printing if
measured values change a little.
[Check]
High-speed
Longer than
3 sec.
[For programming
condition]
[Selecting high-speed
trace printing]



( + )
Standard
Cursor
Cursor
Use at high-speed trace printing
Remarks
Store the selected trace printing
interval into memory.
(Programming change mark is
printed.)
Storing
Reference 2
The selected trace printing interval
value flickers.
Confirmation
Reference 1