Chino AL3000 SERIES, Instructions Manual

Page: 36 / 116

7-3
Parameters
Programming
items
Defaults Programming ranges Entry (Note)
Absolute
value
Max. 5 digits including
signs
Rate-of-
change
Max. 5 digits without sign.
Program a change value
per [measuring intervals x
measuring count].
Alarm
value
Differential
Max. 5 digits without sign.
Program a difference
between reference channel
and compared channel.
Measuring
count
Rate-of-change alarm only 1 to 9
Alarms
1.Absolute value
alarm
2.Rate-of-
change alarm
3.Differential
alarm
Channels
compared
Not programmed
Differential alarm only 1 to n (Number
of channels = 6)
+
Alarm dead
band
- 0.1 0.1 to 9.9(%) …of scale width +
Start time Not programmed* 00 : 00 to 23 :59
(Hour : Minute)
Periodic data
printing
Interval
time
Not programmed*
00H05 (min)
Note
to 23H59(min)
Note) Limited by chart
speed
*Same as in
programming
initialize
Engineering
unit
- V *
*Reflected by range number
programming, (mV, V, °C,K)
Max. 5 digits (Combinations of numeric
values, alphabetic characters, %,°C, °F,
and space)
+
Tag - Not programmed
Max. 9 digits (Combinations of numeric
values, alphabetic characters, %, /,°C, °F,
and space)
+
Burnout
(enabled/disabled)
- non
Select non (Burnout is disabled),
Up burn (higher-limit burnout) or
Down burn (lower-limit burnout) +
Passcode non non (Not programmed)/ 0001 to 9999 Passcode/key
lock
Key lock Unlocked Select locked or unlocked.
(Note) + :Press these keys after pressing key every channel. (Alarm point for Alarms)
3. Programming options
Parameters
Programming
items
Defaults Programming ranges Entry (Note)
Alarm output
Output
number
0
Program output numbers at alarm
programming 0 to 6,
0: No output
+
Speed 1
Speed 2
Chart speed 3
speeds (remote
contacts)
Speed 3
20
0001 to 1500(mm/h)
Note) 3 speeds are selected by remote
contacts terminals.
+