27 / 39
FISIOLASER IRD/IRD 2
! WARNING !
The laser therapy treatments must be provided,
under the strict control of the operator,
to patients conscious , able to interact with
the operator in response to stresses transmitted
by the device ; in case of default to the indications
given , CHINESPORT SpA shall not be consider responsible for any accidents .
! WARNING !
Before every treatment, it is recommended to clean
with caution all of the accessories and the parts of the equipment that have been to
contact with the patient , particularly the ferrule of the laser probes .
After to have selected, for example, the program "Acne" from the internal memory
of the equipment, push on the START button to run the execution of the treatment;
the following screen will be displayed (see fig.23) :
Fig. 23
Once you press the START button, a countdown will start on the TIMER.
This is also noted by an arrow next to the channel (a square indicates non active
channels).
N.B.
: the parameters are highlighted in black if they are being modified. You cannot
modify other parameters, exit the function, or start the therapy if you don’t first
confirm by pressing the knob, or wait a few seconds until it is no longer highlighted.
For example, in Fig.30, channel 2 is not active, but a programme is running on
channel 1.
The writing on the top left of channel <1> shows that the programme displayed is
being run from channel 1.
N.B.
Output channel 1 is the only one available in FISIOLASER IRD.
If you want to visualise the programme loaded on the other channel, you just have to
press the corresponding function-button.
The count-down and the emission continue until :
the set time finishes: when the system will sound intermittent signal tones
for a few seconds.
when the STOP button is pressed: the emission cycle is paused ( Fig.24)
Fig. 24
-
the unit will take up again from the point where it was interrupted when you
press the START button
-
if you press the STOP button again, the emission will be stopped
completely.
As previously noted, the FISIOLASER IRD-series unit is an IR diode laser beam
designed and manufactured in full accordance with national and international safety
standards (see Appendix) .
It is classified as a 3B-CLASS LASER .
This equipment should always be used with caution in order to reduce any risk
(although the risk is contained due to the specific power from IR diode radiation)
that may arise from a laser source which is inherently distinguished by mono-
chromaticity, collimation, coherency and brilliance.
Channel 2
CHANNEL 1
MLA 1/25 Acne
04:57
CHANNEL 2
00:00
* * CHANNEL <1> * *
Channel 2
CHANNEL 1
MLA 1/25 Acne
04:57
CHANNEL 2
00:00
* * CHANNEL <1> * *
