8
EZ LINER EXPRESS
USERS MANUAL
Figure 13
Figure 14
Figure 15
III. Set Stabilization Leg Height
1. Raise the lift by pressing the pump portion of the pedal on the Lift Pump until the mainframe reaches the height where Tower
Insert Plug can be inserted into the Mounting Port on the mainframe (approximately the height where the Safety Latch falls into
the first Latch position) (see Figures 13 and 14).
Pump
2. Pull the spring-loaded release pin on the stabilizing leg to
allow the stablizing legs to lower and lock in the vertical
position (see Figure 15).
3. Unscrew each foot to lower the foot until the foot makes
full contact with the floor (see Figure 15) .
4. Tighten the jam nut against the bottom of each Leg Tube to
lock each Leg height (see Figure 15).
5. Retract all stablizing legs to the horizontal or storage posi-
tion by pulling the spring loaded leg release pin and rotating
the legs up until the legs are locked into the horizontal posi-
tion.
Stabilizing
Leg
Safety Latch
Mounting
Port
Tower Insert Plug
Mainframe
Release Pin
Foot
Jam Nut
Leg Tube
Summary of Contents for EZ LINER EXPRESS
Page 1: ...2013 Vehicle Service Group USERS MANUAL EZ LINER EXPRESS ...
Page 30: ...NOTES ...
Page 31: ...NOTES ...