Chicco Fold & Go i-Size, Instructions Manual

Page: 22 / 164

22
SEAT
1. Remove the cover from the seat by removing
the plastic profiles from the right and left belt
guides (Fig. 33).
2. Release the plastic flaps from under the seat
(Fig. 34).
3. Pull the child car seat fabric out from the Belt
Positioner (Fig. 35).
To cover the car seat, proceed in reverse order
following the instructions above.
7.5 MAINTENANCE AND CLEANING THE
FABRIC COVER
The cleaning and maintenance of the product
must only be carried out by an adult.
HOW TO CLEAN THE FABRIC COVER
The child car seat’s fabric cover can be removed
and washed. Please refer to the care label for in-
structions on washing the fabric:
Machine washable at 30°C
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
• Never use abrasive detergents or sol-
vents.
• Do not dry the fabric cover within a dryer, let it
dry without squeezing it.
The fabric cover must only be replaced with
another cover approved by the manufacturer,
since it is an integral part of the child car seat
and, therefore, one of its safety elements.
WARNING! To ensure the safety of the child car
seat, never use it without its fabric cover.
CLEANING PLASTIC PARTS
Clean the plastic parts only with a soft cloth
soaked in water or a neutral detergent. Nev-
er use abrasive detergents or solvents. The
moving parts of the child car seat must
not be lubricated.
30° C
30° C
30° C
30° C
To adjust:
1. Press the backrest height adjustment lever
(L) on the back of the headrest with one
hand and raise/lower the backrest to adapt it
to the height of the child’s shoulders (Fig. 27).
2. Release the lever verifying that it has been
engaged in the desired position.
7.2 ADJUSTING THE BACKREST WIDTH
It is possible to adjust the width of the backrest
to better adapt the child car seat to the size of
your child. To make the adjustment, use the
backrest width adjustment wheel (K) visible
above the headrest (Fig. 28).
7.3 ADJUSTING THE BACKREST/SEAT ANGLE
You can recline the child car seat using the re-
clining adjustment lever (I). The child car seat
allows reclining the backrest/seat in 4 posi-
tions to allow the child to travel as comforta-
bly as possible. To carry out the adjustment
operations more easily, it is recommended to
remove the child from the seat; otherwise the
operation will be more difficult. To return the
car child seat to a vertical position, use the
reclining adjustment lever (I) to push the seat
towards the backrest of the car seat (Fig. 29).
WARNING! After adjusting the reclining angle,
check that the car safety belts are correctly
tensioned and at most 2 cm above the child’s
shoulder (Fig. 26).
7.4 REMOVING BACKREST/SEAT COVERS
The child car seat cover is fully removable so that
it can be machine-washed. Lift the backrest (C)
completely and widen the side flaps (D).
BACKREST
1. Release the elastic loops from the respective
hooks on the upper and lower sides of the
side flaps (Fig. 30) and remove the fabric
from the flaps.
2. Continue by removing the central part of the
backrest, removing the loops from the right
and left pins (Fig. 31).
3. Complete the removal of the fabric from the
bottom upwards, removing the cover of the
headrest paying attention to the elastic be-
hind the backrest (Fig. 32).