Permatex Part Number
Description
310-JDI-UCA1
Permatex Canister and Wand Assembly
310-81881
Permatex Amber Rust Proofing (24 oz) (Qty of 12)
310-81882
Permatex Amber Rust Proofing (1 gal)
Part Number
Description
178660
Nox Rust X-121B (12 cans per case)
3M® Part Number
Description
08804
Water-Based Undercoat
08801
No Clean-Up Applicator Gun
Anti-Corrosion Treatment and Repair (Base)
Warning: When applying sound deadeners, or anti-corrosion materials due care and preventative measures must be
exercised to prevent any material from being sprayed into door and quarter panel mechanisms such as door locks, window run
channels, window regulators and seat belt retractors, as well as any moving or rotating mechanical or suspension parts on the
underbody, particularly the parking brake cable. After material application, be sure that all body drain holes are open.
Improper application may increase chance of corrosion damage or limit the operation of moving parts, resulting in personal
injury.
Any procedure that disturbs these special treatments, such as panel replacement or collision damage repair operations, may leave
the metal unprotected and result in corrosion. Proper recoating of these surfaces with service-type anti-corrosion material is
essential.
After repair and/or replacement parts are installed, all accessible bare metal surfaces must be treated with metal conditioner and
reprimed. Refer to the GM Approved Refinish Materials book which identifies the paint systems you may use.
The latest revision of the GM Approved Refinish Materials booklet is located on the Goodwrench website at
www.gmgoodwrench.com.
Anti-corrosion compounds are light-bodied materials designed to penetrate between metal-to-metal surfaces, such as pinch-weld
joints, hem flanges, and integral panel attaching points where metal surfaces are difficult to coat with conventional undercoating
materials, and are inaccessible for painting. The materials that are suitable for interior and exterior are listed in the chart below.
Conventional undercoating is recommended in order to coat large areas, such as replacement door and quarter outer panels, floor
pan sections, lids, hoods, fenders, etc. During undercoating operations, care should be taken to prevent the material from being
sprayed into door and quarter panel hardware mechanisms, such as door locks, window run channels, window regulators, and seat
belt retractors. On the underbody, the material should not be applied to any moving or rotating part, energy absorbing bumper
components, or shock absorbers. After undercoating, ensure that all body drain holes are open.
Interior Protectant
The following products are available from GM Dealer Equipment. For technical information, call 187-Permatex (1-877-376-2839):
Exterior Protectants
The following product is available from *ECP, Inc. Contact them at 1-800-323-3521 or www.ecpinc.net.
The following products are available from your local *3M® distributor, or call 1-800-521-8180, ext. 779-5165.
Paint and Coatings
BODY REPAIR
0-3
BACK TO CHAPTER INDEX
TO MODEL INDEX
CHEVROLET SONIC 2012 BODY REPAIR MANUAL
