Center Pillar Reinforcement Replacement
Removal Procedure
Warning:
Refer to
Approved Equipment for Collision Repair Warning
.
Warning:
Refer to
Glass and Sheet Metal Handling Warning
.
Note: The center pillar upper stiffener is made of Dual Phase Steel and should be replaced only at factory joints. Repairing or
sectioning of this part is not recommended. Refer to
Dual Phase Steel
.
1. Disable the SIR system. Refer to
SIR Disabling and Enabling
.
2. Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
3. Remove all related panels and components.
4. Visually inspect the damage. Repair as much of the damage as possible.
5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to
Anti-Corrosion Treatment and
Repair
.
6. Locate and mark all the necessary factory welds of the center pillar reinforcement.
7. Drill all factory welds (1). Note the number and location of welds for installation of the service assembly.
8. Remove the damaged center pillar reinforcement (1).
Installation Procedure
1. Prepare all mating surfaces as necessary.
2. Align the center pillar reinforcement.
Collision Repair
BODY REPAIR
0-3
BACK TO CHAPTER INDEX
TO MODEL INDEX
CHEVROLET SONIC 2012 BODY REPAIR MANUAL
