Challenger Lifts CLM16, Installation, Operation And Maintenance Manual

Page: 23 / 57

Operating Modes
Automatic Mode
Select "automatic mode" by pressing this button on
each column.
Activation of this operating mode is indicated by the
letter
A
on the seven-segment display.
Use these buttons on the control unit to raise or lower the lift. or
Single Mode
Select "single mode" by pressing this button on the
desired column.
Activation of this operating mode is indicated by the
lit LED on the selector button and the letter
S
on the
seven-segment display.
The columns not in single mode are temporarily inoperative. This is indicated
by the letter A flashing on the seven-segment display.
WARNING
!!! SAFETY WARNING !!!
!!! DO NOT TILT VEHICLE !!!
Use these buttons to raise or lower the lift.
NOTE:
The single mode can also be used for several columns simultaneously.
Height offsets between individual columns will be maintained after switch-
over to automatic mode. The offset can be removed either
– by equalizing the carriages in single or group mode or
– by lowering all carriages to bottom position in automatic mode.
Lift stops once first carriage reaches upward travel stop.
or
CLM16 IOM.
DOC
5/8/09