page 96
page 96
www.centsys.com
Once assembled with the long drive arm, the format should look as shown in Section 13,
Figure 19.
1. The drive arm must point as is shown in Section 13, Figure 19
2. The notch must be at the bottom of the shaft (6 o’clock)
3. The bolt head must face the bottom and the nut on top
4. The angle of the bolt and nut must be as shown (11 o’clock)
STEP 9
Replace the bearing housing bolts once everything is in the correct orientation.
Hand-tighten for the time being.
RHS FLUSH MOUNT - SIMILAR DIRECTION OF TRAVEL
SECTION 13
FIGURE 19
VIEW A
11 o’ clock
6 o’ clock
1
3
4
2
Summary of Contents for CLAWS
Page 51: ...page 51 www centsys com Notes...
Page 69: ...page 69 www centsys com Notes...
Page 87: ...page 87 www centsys com Notes...
