page 107
page 107
www.centsys.com
Lift the spikes by hand to get them just under the level of the trench plate,
which pushes the linkage arm back, allowing you to move the unit into its
correct position; 110mm from the front edge of the Linkage Cover Plate.
(Section 13, Figure 61).
13.5.2. Fitting and leveling the SECTOR II boom pole
Refer to Section 3.3 of the SECTOR II Installation manual for instructions on
fi
tting and
leveling to boom pole.
SECTOR II
M12x60
Hex Bolt
Heavy duty
washer
Hold down
bracket
Drive linkage
assembly
SECTOR II
Drive linkage
cover plate
110mm
FIGURE 61
FIGURE 62
STEP 3
STEP 4
RHS FLUSH MOUNT - SIMILAR DIRECTION OF TRAVEL
SECTION 13
13.5. Integrating the SECTOR II with the CLAWS
13.5.1. Placing the SECTOR II into position
Drive linkage
unit
SECTOR II
SECTOR II
Ground
level
Drive linkage
end cover
Drive linkage
frame
Drive linkage
cover plate
Y
Y
FIGURE 59
FIGURE 60
STEP 1
STEP 2
Summary of Contents for CLAWS
Page 51: ...page 51 www centsys com Notes...
Page 69: ...page 69 www centsys com Notes...
Page 87: ...page 87 www centsys com Notes...
