page 72
www.centsys.com
Once assembled with the short drive arm, the format should look as shown in
Section 9, Figure 12.
1
3
4
2
VIEW A
11 o’ clock
1.5X
X
6 o’ clock
1. The drive arm must point towards the longer side of the drive linkage assembly (1.5x)
2. The notch must be at the bottom of the shaft (6 o’clock)
3. The bolt head must face the bottom and the nut on top
4. The angle of the bolt and nut must be as shown (11’clock)
STEP 11
Replace the bearing housing bolts once everything is in the correct orientation.
Hand-tighten for the time being.
FIGURE 12
1.5X
LHS SURFACE MOUNT - OPPOSING DIRECTION OF TRAVEL
SECTION 9
Summary of Contents for CLAWS
Page 51: ...page 51 www centsys com Notes...
Page 69: ...page 69 www centsys com Notes...
Page 87: ...page 87 www centsys com Notes...
