page 106
page 106
www.centsys.com
M8x25
screw
Sprign Washer
M8x20 screw
Drive linkage
cover plate
It is imperative that the drive linkage cover plate is placed correctly.
Make sure that there is clearance for the drive arm to swing through. If this
plate is assembled back-to-front the drive arm won’t swing through and you will
need to turn the plate around (Refer back to Section 13, Figure 20).
FIGURE 56
FIGURE 58
FIGURE 57
STEP 2
STEP 3
STEP 3
RHS FLUSH MOUNT - SIMILAR DIRECTION OF TRAVEL
SECTION 13
13.4. Re-assembling the trench plate and linkage covers
Trench plate
covers
Take notice of the slot orientation in the trench cover plates before it is placed
back into position. The spike must rest on the straight edge of the slot when it is
in its upright position.
FIGURE 55
STEP 1
Summary of Contents for CLAWS
Page 51: ...page 51 www centsys com Notes...
Page 69: ...page 69 www centsys com Notes...
Page 87: ...page 87 www centsys com Notes...
