CAS CL5000J Series, Owner'S Manual

Page: 59 / 95

60
If you know the scale’s IP address and your PC has the registered PC program, you can
access scale individually or all together to monitor report and update PLUs.
NOTE: If you have set HUB (Bridge, Repeater, etc...) use PC manager to search
correspond scales
For setting figure 1, 2 network setup; you must input individual IP address for
connection test.
Figure 3 show that scales are connected via internet; when you know the scale IP
address, you can access any other network scale.
4. Before setting the network
■ Each scale needs fixed IP address.
■ Do not use DHCP without prior notice to CAS. If so CL-Works will not able to retract
the right scale because access IP address will change constantly.
■ You need to assign proper IP, Gateway, Subnet Mask address from webmaster.
NOTE: These 3 elements are basic information to operate internet / intranet.
Please get prior training on internet network; otherwise recommend to get advice from
network management person.
■ You can set scale up to 99 for PC control networking.
2.10.2 Network Setting (Menu code 1910)
( MENU → Communication → Network Setting )
No Sub-menus Description
1 DHCP Dynamic Host Configuration Protocol
2 IP Setup IP add, subnet, gateway and Port Number..
3 RS232C Setting of the b-rate.
2.10.3 DHCP (Menu code 1912)
( MENU → Communication → Network Setting → DHCP )
Setting Dynamic Host Configuration Protocol
This mode for Automatic Private IP Addressing.
Your network has stable DHCP sever, It is very useful mode.