6
Moving the Balance
•
Before moving the balance, confirm that it is not in the process of
span calibration. Unplug the AC adapter from the power outlet
and transfer the balance.
Disconnecting the power supply or moving the balance during span
calibration or check may cause balance failure.
3.
WARM-UP
•
Warming- up the balance for at least four (4) hours allows for
accurate measurement.
•
Do not disconnect the AC adapter even when the balance is not in
use.
Instead, press the POWER/BRK key to put the balance in the
STAND-BY (warm- up) mode.
•
Disconnect the AC adapter from the outlet if the balance will not
be used for a period of one month or longer.
4.
PRECAUTIONS
Observe the following precautions.
Note:
•
Do not insert metal tools inside the balance housing.
•
Do not open the balance housing.
•
Do not allow water or other liquids to enter the balance housing.
•
Do not place a load on the pan that exceeds the mass range of the
balance.
•
Do not allow magnetized articles near the balance.
•
Do not connect any instruments to the balance connectors other
than those designated in this manual.
•
Do not drop anything on the pan.
•
The doors to the weighing chamber are glass. Open and close
them carefully.
•
Before transporting the balance, pack the balance into the original
shipping carton to prevent damage.
