Carl Valentin DPM III XI, Operating Manual

Page: 81 / 96

DPM III xi series Error Correction
04.18 Operating manual 81
Error message Cause Remedy
101 Lower position
Sensor signal down is missing
(option APL 100).
Check input signals /
compressed-air supply.
102 Vacuum plate empty
Sensor does not recognise a
label at vacuum plate
(option APL 100).
Check input signals /
compressed-air supply.
103 Start signal
Print order is active but device
not ready to process it.
Check start signal.
104 No print data
Print data outside the defined
label.
Selection of wrong module type
(design software).
Check selected module type.
Check selection of left/right
version.
105 Printhead
No original printhead is used. Check the used printhead.
Please contact your distributor.
106 Invalid Tag type
Wrong Tag type.
Tad data do not match the Tag
type in the printer.
Adapt data or use the correct
Tag type.
107 RFID invalid
RFID module is not activated.
No RFID data can be
processed.
Activate RFID module or
remove RFID data from label
data.
108 GS1-128 invalid
Transferred GS1-128 bar code
is invalid. Verify bar code data (see GS1-
128 bar code specification).
109 EPC parameter
Error at EPC calculation. Verify data (see EPC
specification).
110 Housing open
When starting the print order
the housing cover is not closed. Close the housing cover and
start the print order anew.
111 EAN.UCC code
Transferred EAN.UCC code is
invalid. Verify bar code data (see
corresponding specification).
112 Print carriage
Printing carriage does not
move. Check gear belt (possibly
broken).
113 Applicator error
Error while using applicator. Check applicator.
114 Left position
Left final position switch is not
in correct position. Check LEFT final position
switch for correct function and
position.
Check function of pneumatics
for cross traverse.
115 Right position
Right final position switch is not
in correct position. Check RIGHT final position
switch for correct function and
position.
Check function of pneumatics
for cross traverse.