DE-LEARNING A PENDANT
It may be necessary in some circumstance to uncouple or de-learn a
pendant from a Smart Dialler. To de-learn, place the function switch at
the rear of the dialler to ‘set’, lift up the phone connected to the dialler
and (press ‘talk’ if a cordless phone) then press star zero (* 0) and when
the letter “d” (for de-learning) appears on the LED display on the dialler
press star zero hash (*,0,#). You will hear a double beep. Test by pressing
the yellow button and if the dialler no longer responds to the pendant
yellow button, you have successfully de-learned the pendant.
Changing the Batteries cont:
2.
To change the Wireless Pendant battery you will need a small Phillips head
screwdriver. This Wireless pendant is very delicate and so care should be
taken when changing this battery. As shown in Fig 1 diagram below, undo
the 4 screws and carefully change the 23 A 12 Volt battery ensuring that
the battery polarity is correct (+ve & -ve). Replace the cover correctly and
secure it with the screws. These Screws should be relatively tight without
using excessive force! But ensure the backing plate has pressed tight to
the seal.
3.
After changing the rechargeable battery it is important that you test the
unit for correct function.
23
22
TROUBLESHOOTING
De-Learning a Pendant
It may be necessary in some circumstance to uncouple or de-‐learn a
pendant from a Smart Dialler. To de-‐learn, place the function switch at the
rear of the dialler to ‘set’, lift up the phone connected to the dialler and
(press ‘talk’ if a cordless phone) then press star zero (* 0)
and when the letter “d” (for de-‐learning) appears on the
LED display on the dialler press star zero hash (*,0,#). You
will hear a double beep. Test by pressing the yellow button
and if the dialler no longer responds to the pendant yellow button, you have
successfully de-‐learned the pendant.
Trouble Shooting
PROBLEM
CAUSE
REMEMDY
Warning voice message
heard saying “mains
power is not detected”.
•
A power failure
•
The AC power
adapter plug has
come out of the
power outlet
•
Power adapter
faulty
•
Wait until power supply
resumes.
•
Plug the adapter back in.
•
Replace Power Adapter
The Dialler is not
accepting or displaying
the programming
commands as shown on
Pages 6-‐10
•
If using a cordless
phone you have
forgotten to press
'talk' button first
•
The “FUNCTION”
switch is not in the
“SET” position.
•
The phone you are
using to program
is not compatible
•
The AC power
adapter plug has
come out of the
power outlet.
•
The cable from the
phone is not
connected to the
port marked 'TEL'
on the Smart
Dialler
•
If cordless phone ensure
you press 'talk' first before
programming
•
Place the “FUNCTION”
switch to “SET” position.
•
Try another phone.
•
Plug the adapter back in.
•
Ensure phone cable from
fixed phone or cordless
cradle is connected to
'TEL' port on Dialler
