Time programming procedure
- Maximum work time: 180 seconds
- Maximum pause time: 60 seconds
1) Press and hold down button "
P
" PROG until LED "
L3
" lights up.
2) Close the rolling shutter completely using button "
P2
" MEMO/DEL (this action is carried out in the "manual
mode").
3) Press button "
P
" to start the opening manoeuvre.
4) When the rolling shutter arrives at the completely open position and the opening travel limit activates, cutting
off power to the motor, wait 3-4 seconds and then press "
P
" again; the LED "
L3
" will start to flash indicating
that the pause time count has started.
5) The next time you press "
P
" the pause time will stop and the rolling shutter will begin to close.
6) When the shutter is completely closed and the closing travel limit activates, cutting off power to the motor, wait
3-4 seconds and then press "
P
"; at this point time programming has ended and LED "
L3
" will switch off.
Note:
after activating the programming procedure, step 2 can also be carried out by pressing the button "
TC
", and
from step 3 onwards you may proceed using the opening button "
TA
".
Attention!
If at the end of time programming the LEDs "
L2
" and "
L3
" flash simultaneously the operation was
not successful and you will have to repeat the procedure from step 1.
Function mode
• Semi-automatic
(Dip 1 = OFF, Dip 2 = OFF)
- automatic reclosing deactivated
- each transmitter channel works as a sequential command.
Open - Stop - Close - Stop.
• Semi-automatic
(Dip 1 = OFF, Dip 2 = ON)
- automatic reclosing deactivated
- the transmitter channels have the following functions:
A - Open - B - Close - C - Stop - D - Sequential.
• Automatic
(Dip 1 = ON, Dip 2 = OFF)
- automatic reclosing enabled
- the transmitter channels have the following functions:
A - Open - B - Close - C - Stop - D - Sequential.
• Manual mode
(Dip 1 = ON, Dip 2 = ON)
- manual operation during closing.
- the closing photocell "
FTC
" intervenes blocking the motor
- the sequential command has no effect
- the transmitter channels have the following functions:
A - Open - B - Close - C - Stop - D - No function.
Anemometer functions
•
The anemometer cuts in after the non adjustable threshold of about
35 Km/ora
has been reached (measured
using the Cardin anemometro
SW0
)
• The anemometer only causes closing when the shutter is in movement and blocks the radio transmitter com-
mands for 10 minutes. The terminal board commands are still enabled.
• When the shutter is completely closed or the
TB
button has been activated the anemometer will be ignored.
• If, during the closing stage (caused by the anemometer)
FTC
,
CSP
or
CSA
cuts in, the system will invert travel
direction until it reaches the completely open position and then:
- close again after five seconds in the presence of wind;
- if automatic closing is enabled the shutter will close again after the programmed pause time has elapsed.
Note:
- Bridging the "
TA
" and "
TC
" contacts will transform "
TA
" into a sequential command with the functions
Open-
Stop-Close-Stop
.
- The "manual" manoeuvre function can also be obtained by simply keeping the "
TA
" button (or the "
TC
" button)
held down for more than one second.
- If a security device is in alarm (stop button or photocell) the LED "
L3
" will flash quickly.
1
2
1
2
2
1
2