1VV0301421, Rev 1.2
Copyright © 2017 Telit. All rights reserved.
This Quick Start Guide will walk you through the steps required to
demonstrate HomeKit AEK/ADK on GS2200M SKB (Starter Kit
Board).
GS2200M SKB Hostless
HomeKit AEK/ADK
The GS2200M_SKB has the GainSpan Wi-Fi module and the
Apple Wireless Accessory Configuration Chip (WAC) installed on
the board.
Your kit contains:
•
Quick Start Guide (this document)
•
GS2200M_SKB with WAC
•
Serial Cable (USB to Mini-USB)
1
Build the AEK/ADK Package
2
Program the SKB
For ADK including SDK package,
Click
Build
option to generate the HomeKit binaries.
The build configuration is submitted and a confirmation e-mail is sent
notifying that the HomeKit AEK package or the HomeKit ADK
(including SDK) package is complete and ready to download.
Download and unzip the package, for firmware binaries.
Step
1
Plug the mini-USB cable, one end of the
USB
port to
GS2200 SKB USB and the other end of the USB port to the
computer or laptop.
Quick Start Guide
Step
1
https://wifi.telit.com/secure/login
SDK
Builder
tab and proceed to select the following options as seen
below:
If you do not have a login, sign up and register for a portal account
at:
https://wifi.telit.com/secure/register
For AEK Package:
For ADK Package (including SDK):
Step
3
Switch SKB power switch to the ‘ON’ position and check
if the green LED near the switch is illuminated.
Step
2
Ensure the Power Measurement Switch SW6 is in the
“ACTIVE” Position.
Step
2
For AEK package,
• Click
Next
to navigate to the
Build
option.
• Click
OK
, and then click
Build
to generate the Home-
Kit binaries.
