Canon LV-7565, Specification, Page: 21 / 47

Expand Serial Command Specification Page 20 of 46
8.5.6. CF_DDOTS Command
Command “CF_DDOTS_%1” [CR]
%1
“0100 ~ nnnn” -------- Directly set Display Dots
“nnnn” means maximum value. This result of current
Total
Dots – Horizontal Position
“UP” --------------------- Display Dots setting value +1
“DN” --------------------- Display Dots setting value -1
Details
Set Display Dots. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
the screen. To show up on the image, issue CF_SETPCADJ Command.
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- When Input is Video series
8.5.7. CF_DLINE Command
Command “CF_DLINE_%1” [CR]
%1
“0100 ~ nnnn” -------- Directly set Display Line
“nnnn” means maximum value. This result of current
Total
Line – Vertical Position
“UP” --------------------- Display Line setting value +1
“DN” --------------------- Display Line setting value -1
Details
Set Display Line. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
the screen. To show up on the image, issue CF_SETPCADJ Command.
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- When Input is Video series
8.5.8. CF_SETPCADJ Command
Command “CF_SETPCADJ” [CR]
%1
N/A
“EXT6” ~ “EXT60”
Details
1. Execute the setting value in PC adjustment menu to show up on the screen.
When %1 is directly set by PC Control Command as below and Screen
Control Command, the Command will not be executed. This Command,
“CF_SETPCADJ” is to execute the setting value. (Only valid when it is in
the normal Power On state.)
*CF_FSYNC *CF_TDOTS
*CF_CLAMP *CF_H-POS
*CF_V-POS *CF_DLINE
*CF_DDOTS *CF_FLSCREN
2. When %1 is ”EXT6” ~ “EXT60” is set to %1, content specified %1 by EXT
No.6 (not XGA No.1) will be displayed.
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- When Input is Video series