Expand Serial Command Specification
Page 15 of 46
8.4.4. CF_TINT Command
Command “CF_TINT_%1” [CR]
%1
“000 ~ 063” -------------- Directly select the Tint setting value
“UP” ----------------------- Tint setting value +1
“DN” ------------------------ Tint setting value -1
Details
Set the User control Tint value.
The value set by their Command will not be saved to the Projector.
Therefore, when All Off the Projector, the value will return to the original
setting. (For Stand-by mode, this value stays.)
Only valid when it is in the usual Power On state.
Acceptable
“000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.5. CF_SHARP Command
Command “CF_SHARP_%1” [CR]
%1
“000 ~ 031” -------------- Directly select the Sharpness setting value
“UP” ----------------------- Sharpness setting value +1
“DN” ------------------------ Sharpness setting value -1
Details
Set the User control Sharpness value.
The value set by their Command will not be saved to the Projector.
Therefore, when All Off the Projector, the value will return to the original
setting. (For Stand-by mode, this value stays.)
Only valid when it is in the usual Power On state.
Acceptable
“000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.6. CF_GAMMA Command
Command “CF_GAMMA_%1” [CR]
%1
“000 ~ 015” -------------- Directly select the Gamma setting value
“UP” ----------------------- Gamma setting value +1
“DN” ------------------------ Gamma setting value -1
Details
Set the User control Gamma value.
The value set by their Command will not be saved to the Projector.
Therefore, when All Off the Projector, the value will return to the original
setting. (For Stand-by mode, this value stays.)
Only valid when it is in the usual Power On state.
Acceptable
“000” [CR]
Response
Unacceptable “Error Code” [CR]