Canon iR6570 series, Portable Manual

Page: 89 / 320

0001 An open circuit has been detected for the
count pulse signal.
Turn off the main power, and check for an
open circuit in the cable; then, turn the
main power back on.
E061 There is a potential control error/there is an APC error.
0001 As a result of potential control, the drum
surface potential (VL2) of the background
is 200 V or higher (i.e., causing a solid
black image).
- Replace the potential sensor unit.
- Replace the laser scanner unit.
- Replace the DC controller PCB.
0002 The primary charging output used at time
of printer output and the drum surface
potential after laser output is identified as
being 200 V or more (i.e., causing a solid
black image).
E100 There is a BD error.
0001 A check is made of VLOCK at intervals of
100 msec while the laser is on. An error
will be identified if it is not detected 10
times in sequence.
- Replace the laser scanner unit.
- Replace the DC controller PCB.
E110 There is a polygon motor error.
0001 - Although the polygon motor has been
turned on, VLOCK is not detected at all
within 76.5 sec.
- At time of a shift from full-speed to half-
speed control, VLOCK is not detected at
all for 7.5 sec.
- At time of half-speed control, a check is
made of VLOCK at intervals of 100 msec.
An error will be identified if it is not
detected 10 times continuously.
- Replace the laser scanner unit.
- Replace the DC controller PCB.
E121 There is a controller cooling fan error.
0001 Even though the controller cooling fan has
been turned on, the controller cooling fan
stop signal has been detected for 5 sec or
more.
- Check the connector for any fault in
connection.
- Replace the fan.
E196 The EEPROM is faulty.
Code Description Remedy